"Don't struggle with poorly fitting spanners and buy this purpose designed flare spanner which is ideal for use on vehicle brake pipes."... (read full reviews)
"strong, basic sliding t-bar. wanted a cheap ratchet socket but was out of stock and this was the cheapest alternative, strong and basic design (not a bad thing being basic) . might make removing hard"... (read full reviews)
"I hadn't realised this is so much wider than a standard open end spanner. That makes it much less likely to round off the nut. Great quality."... (read full reviews)
"I am at college doing Electrical and these strippers are the best thing ever. easily strip wires in seconds. Helps get work done faster too."... (read full reviews)
"I needed a TX45 bit to carry out an oil change on a 2000 'W' Reg Vectra B 2.0 Dti, this was the perfect size required for the oil sump plug to drain the oil. In stock and reserved, collected within 30"... (read full reviews)
"This costs a little more than some tools but its money well spent.
I have rounded many a nut with my pound shop tools in the past, not so with this range of tools.
I have a set of these combination"... (read full reviews)
"Does what it's supposed to, nicely made, superbly finished, a pleasure to use.
One definite plus compared to other such ratchet wrenches I've looked at - the ratchet wheel is perfectly symmetrically"... (read full reviews)
"Nice quality, balanced spanned that you can tell is made to last stright from the off. Slim profile & well finished. Granted it is not cheaply priced but it is not cheaply made either - you get what"... (read full reviews)
"I've been building my tool collection up for over 14years and I have found halfords sockets, spanners & ratchets are the best value and really are top quality.
Lifetime warrety so keep your"... (read full reviews)
"dont throw your old rachets away buy a cheap repair kit from halford and make your rachets new again,
halfords are the only company I know that do this,
there pro tools are the best,
I have had them"... (read full reviews)
"What can one say about a 3/8" drive 10mm Hex driver. It's the right size? Yes. It didn't break in use? No, it didn't. How can you review a tool unless it lets you down? Short answer, you can't. Get"... (read full reviews)